1
This section of the document describes the use of
the ‘Set-up’ menu, which allows you to fine-tune Solo
Movie 5.1 to the other items in your system (such as
your video display, speakers and room layout), and to
configure some personal preferences.
Obtaining a picture
To view the Set-up menu for the initial configuration,
we recommend the use of the composite video
output to connect to your display device. This is
because the high quality video output has several
display modes and may be incompatible with your
display device in its default configuration.
Ensure that your display device is switched on and
that you have selected the correct video input. You
should see the screen shown below. This is the image
that Solo Movie 5.1 gives when there is no disc
playing.
The Display set-up menu
For optimum video performance it may be necessary
to configure your display for the video source – Solo
Movie 5.1, in this case. A series of test patterns
generated by Solo Movie 5.1 allows you to optimize
colour balance, contrast, brightness and to centre
your picture. Full instructions for each test pattern
are displayed on the screen before the test pattern is
shown.
To enter the Display set-up menu
, move the
cursor down to the ‘Display’ button on the screen and
press
OK
. Follow the on-screen instructions and press
SeTUP
at any time to quit from a page (or press
OK
on the last screen to Exit).
advanced
set-up
Using the Set-up menus
Your Solo Movie 5.1 has two different set-up menus:
<
The Set-up menu allows configuration of all
aspects of Solo Movie 5.1. Configurable items
and their potential values are described on the
following pages.
<
The Display set-up menu is a series of video
test patterns with instructions that help you to
optimize your display for Solo Movie 5.1.
Remember that to use the CR100 remote
control for advanced set-up, you first have to
set it to AMP or DVD mode by pressing the
AMP
or
DVD
button.
The Set-up menus
To enter the Set-up menus:
1. Press and hold the front panel
MeNU
button for
more than one second.
or,
1. Using the remote control, press the
AMP
or
DVD
button to ensure that the CR100 is in one
of these modes
2. Press the
SeTUP
button.
You can press
MeNU
(front panel) or
SeTUP
(remote
control) at any time to quit from a page and save all
the settings.
The Set-up menu comprises six pages of options.
– Operation, Video, Audio, Speakers, Delays and Trims.
The tabs on the left side of the screen show the
pages available. To change between pages, move the
menu highlight to the appropriate tab (using the
D
,
E
,
B
and
C
buttons).
To change an item, first use the
BC
controls to
highlight the item, then press
OK
to open the list of
options for the menu item. The current option for the
menu item is ticked. Select a new option using the
BC
controls and confirm the selection with
OK
.
(If the item to be changed is controlled by a slider,
press
OK
to activate the slider, move it using the
D
E
controls, confirming the setting with
OK
.)
Note that options that are not currently applicable are
shown ‘greyed out’, and cannot be highlighted or changed.
Screen saver
To protect your screen from damage from a
persistent static image, a screen saver starts after a
few minutes of inactivity.
An Arcam logo appears at random locations around
the screen. To restore the previous screen image,
press the
<
(stop) button on the front panel or the
remote control.
���
���