Arbor Technology ARTS-4770, User Manual

Page: 64 / 103

- 54 -
Installation & Maintenance
4.3.2 Automation Application
1. To turn off the Vehicle Acc for Automation application,
please refer to Jumper setting of
JACON1 on page 19
2. Before wiring, make sure the power source is
disconnected.
3. Find the terminal block in the accessory box.
4. Use the wire-stripping tool to strip a short insulation
segment from the output wires of the DC power source.
5. Identify the positive and negative feed positions for the
terminal block connection. See the symbols printed on
the rear panel indicating the polarities and DC-input
power range in voltage.
6. Insert the exposed wires into the terminal block plugs.
Only wires with insulation should extend from the
terminal block plugs. Note the polarities between the
wires and the terminal block plugs must be positive to
positive and negative to negative.
7. Use a slotted screwdriver to tighten the captive screws.
Plug the terminal block firmly, which wired, into the
receptacle on the rear panel.
Vcc GND Acc
receptacle
+ -
DC-IN
terminal block
captive
screw
connect
power adapter