Last Rev Date: 07/11/12
Page 8 of 18
Fitting instructions# 3787907
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
VEHICLE PREPARATION 2011 ON VEHICLES
26.
As accurately as possible, using 50mm
masking tape, place the bottom edge of
the tape along the marks for the cutting
edge right across the bumper and
flarets.
NOTE: This is intended to be a straight
horizontal cut across the bumper. A laser
level is the optimum way to ensure the cut
is level. If you can get access to one use it
once you have ensured the car is level.
If the cutting line appears to be crooked or
uneven, reapply the tape so it is straight.
NOTE: If fog lamps are fitted, disconnect
them. Check that there is nothing behind
the bumper such as wiring in the cutting
path before proceeding
27.
Using the lower masked line as a guide
accurately cut the bumper facia with an
air hacksaw or jig saw or similar (always
use eye and ear protection).
NOTE: You may need to use a hand
saw to cut through the bumper
behind flaret on the flared bumper
version as shown. Ensure the saw is
horizontal.
Warning: Drilling operations can result in flying
metal debris, safety glasses should be worn.
Align lower tape edge accurately to
marked line
