Last Rev Date: 07/11/12
Page 4 of 18
Fitting instructions# 3787907
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
VEHICLE PREPARATION 2005 -2011 VEHICLES (FOR 2011 ON VEHCILES
GO TO STEP 19)
BUMPER CUT
1.
Cut out the relative supplied bumper
cutting template to suit the bumper type
– flared or non flared.
2.
Flared bumpers have a flaret attached,
leave this on the bumper on for marking
and cutting
3.
Carefully and accurately apply the
cutting template to the outer corner of
the bumper on the RHS as shown,
lining up the
bumper to fender join
,
wheel arch and headlamp lower
edge
. Use masking tape to secure in
position.
4.
Accurately mark cutting line using a
marking pen
5.
Repeat by reversing template for LHS
6.
Accurately mark cutting line reference
points at either end of the outer
openings of the air intake as shown on
the flat section (don’t measure on the
corner radius)
Note: Masking tape shown for reference
7.
Accurately measure and mark at the
center of the bumper facia up at two
points on either end of the number plate
boss top face as shown.
Note: Masking tape shown for reference
Measure up
and mark
at198mm
(lower edge of
masking tape)
Measure and
mark at 158mm
(lower edge of
masking tape)
158
198
