Last Rev Date: 07/11/12
Page 12 of 18
Fitting instructions# 3787907
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
BULL BAR PREPARATION
48.
Working within the bull bar, insert 2 x
M6 caged nuts to inside front face of
top pan.
NOTE: Caged portion faces the rear of the
bar.
49.
Fit 4 x M8 cage nuts across inside of
lower pan as shown
50.
Remove the fastening screws and nuts
supplied with the turn signal/clearance
lamps and replace these with the four
screws provided in the kit. Push the
square plastic plugs into the holes on
the turn signal bracket. Fasten the turn
signal lamps to the bull bar as shown.
NOTE: - The drain holes in the lamp are at
the bottom. (As shown)
IMPORTANT: -
The turn signal (amber section) is to face to
the inside of the bull bar.
IF FITTING A WINCH
51.
To fit an 8/9000lb or 9.5XP winch,
rotate gearbox 72° counter clockwise.
52.
Stand winch upright and undo the
capped head screws and by lifting the
gearbox only a couple of millimetres,
rotate the gearbox. Once in position,
refit all screws and tighten firmly.
WARNING: Do not lift gearbox more than a
couple of millimetres.
ORIGINAL
VIEWED FROM
LHS OF VEHICLE
ROTATED
