Last Rev Date: 07/11/12
Page 13 of 18
Fitting instructions# 3787907
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
BULL BAR PREPARATION
53.
Remove the cover from the control box.
54.
Replace the three main power cables
that go from winch to control box. Make
sure that you identify the colour codes
on the new cables before closing
control box cover.
55.
This must be done for whatever winch
is to be fitted to the bull bar.
56.
Bolt the control box bracket to the
control box then thread the cables
through the aperture cut into the top of
the pan.
57.
Mount the control box bracket onto the
top pan, using M8 bolts, flat washers
and flanged nuts. Use the cable ties to
ensure the winch cables are secure,
clear of moving parts and sharp edges
and tie them together.
58.
Place winch on a stand with mounting
holes facing upwards and lower bull bar
onto winch. Align all four holes, using
the original 3/8” bolts that came with the
winch in the top two holes and the
longer 1 ¾” x 3/8” bolts, supplied in the
kit, in the lower two holes plus 3/8”
spring and flat washers with each bolt.
59.
When all bolts are fitted and finger tight,
tighten top holes only, using a stepped
ring spanner and remove lower bolts.
