Last Rev Date: 07/11/12
Page 7 of 18
Fitting instructions# 3787907
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
VEHICLE PREPARATION 2011 ON VEHICLES
BUMPER CUT
19.
Cut out the relative supplied bumper
cutting template to suit the bumper type
– flared or non-flared.
20.
Flared bumpers have a flaret attached,
leave this on the bumper on for marking
and cutting
21.
Carefully and accurately apply the
cutting template to the outer corner of
the bumper on the RHS as shown,
lining up the
bumper to fender join;
wheel arch and headlamp lower
edge.
Use masking tape to secure in
position.
22.
Accurately mark cutting line using a
marking pen
23.
Repeat by reversing template for LHS
24.
Accurately mark cutting line reference
points at either end of the outer
openings of the air intake as shown on
the flat section (don’t measure on the
corner radius)
Note: Masking tape shown for reference
25.
Accurately measure and mark at two
points on either end of the number plate
boss top face as shown.
Note: Masking tape shown for reference
Measure up
and mark at
90mm from the
top ceiling of
the lower grille
aperture.
Measure and mark
10mm from the top
of the raised
number plate boss
of the bumper.
10mm
90mm
