Aras CTINT1000, User Manual

Page: 32 / 42

User’s Manual
26
4.6 Event
You can set up event detection and actions to be taken. When you click the
Event
menu on the Remote Setup screen, the current Event settings are
displayed on the right side of the screen.
Alarm In
Check the
Alarm In
box to set up an alarm-in event. When
the transmitter senses an input on the alarm input connector,
it considers it as an event. Enter the alarm-in device’s
name and select the alarm-in type.
y
Event Action : Check the box for each action the
transmitter will take whenever it detects an alarm-in
event.
í
Alarm Out : Select to trigger an alarm-output signal.
í
Send Email : Select to send an Email. Selecting a camera
in the Image Attachment field attaches the event detected
image file (.JPG) when sending an Email.
í
Remote Callback : Select to send a message to remote sites and select the desired remote sites.
í
Move PTZ to
: Select the desired preset number to move a PTZ camera to the previously saved preset
location. You must set up preset locations of PTZ cameras during 3.2 Setup – Camera/Audio Setup .
NOTE: You must properly configure the settings related to each event action during the 4.6 Event –
Event Action setup to enable event actions.
Motion Detection
Check the Motion Detection box to set up a motion
detection event. When the transmitter detects a motion
in a configured motion detection zone, it considers the
motion as an event.
y
Sensitivity : Set the motion sensitivity for daytime and
nighttime independently.
y
Minimum Blocks for Detection
: Adjust the minimum
number of detection blocks (1 to 192) that must be
activated to be considered as a motion event for daytime
and nighttime independently.