ARAG Skipper LT, Installation, Use And Maintenance Manual

Page: 47 / 56

47
8.4.3
F3
Job
resume
Activate the procedure to resume a spraying job previously interrupted (Fig. 139)
Fig. 139 Fig. 140
Fig. 141
Fig. 142
Fig. 143
Fig. 144
When resuming an "old" job, Skipper LT gives guidance indications
by recalling active conditions upon saving:
- Guidance mode.
- Marking points A and B.
- Marking points to calculate the area.
1
Press
F3
to resume a job previously interrupted, among the saved ones. Confirmation prompt is displayed to start procedure.
2
Press
OK
. Skipper LT requests you to save job you were carrying out before starting the procedure.
Press
OK
(
3a
) or
ESC
(
3b
):
3a OK
allows you to save job: enter a name (Fig. 141). Type in name as described under par. 6.3 - Using the programming keys.
3b ESC
lets you go to machine selection page (Fig. 142) without saving job: work data displayed so far will be lost.
4
Press keys to select the "machine"* in use among the listed ones.
5
Press
OK
to confirm machine selection.
6
Skipper LT asks you to select job to be resumed. Press keys to select among listed jobs.
7
Press
OK
to confirm machine selection. Drive and perform the job.
*
"machine": includes all settings you set up during Skipper LT programming (chapt. 6.5), concerning tractor you will use for the job.
For instance, you could use Skipper LT with many machines so to obtain the correct information you shall recall the features of the machine in use.
WORK FUNCTIONS - PAGE 4