34
USE
7.4
Spraying a field
Fig. 101
Let's consider to wish to spray field by parallel lines,
but only after spraying field borders.
• Switch
Skipper LT on (par 6.1).
After self-diagnosis routine, system asks if you wish to continue a previous job (Fig. 101).
Press
ESC
to start a new spraying job.
• Select guidance mode you wish to use during spraying job: execute function
(par. 8.2.2).
• Set at the beginning of field to spray (Fig. 102).
• Start spraying by working the relevant activation command according to system in use:
press
USER
key and enable spraying job on machine.
• Start driving along field border. During this path, message
Mark A?
is displayed.
Fig. 102
marking Points a and b
• While driving field border you will mark two points A and B
(as described under par. 8.3.1 - function
).
This step is essential to allow Skipper LT to guide you, during the job, along
tracks parallel to the reference one, obtained by marking points A and B.
We recommend that you mark A and B at the ends of a straight
length as long as possible and while vehicle is moving: the
longer the marked length across points A and B, the lower the
error caused by your deviation while driving.
Fig. 103
• Once straight line A/B (
t0
) is tracked, the whole field could be sprayed
along tracks parallel to it (Fig. 103), following the reference tracks that will
be displayed (Fig. 104).
Fig. 104
Summary of Contents for Skipper LT
Page 1: ...Satellite navigator Software rel 2 0X INSTALLATION use and maintenance 467020...
Page 53: ...Notes 53...
Page 54: ...Notes 54...
