Aquos xx3 mini, User Manual

Page: 181 / 186

179
Safety Precautions
AQUOS Xx3 mini
Care & Maintenance
・Proper care of Card Slot Cap gasket is crucial for continued
handset water and dust resistance. Observe the following:
・Do not remove or damage gasket. Keep it clean.
・If Card Slot Cap is damaged or deformed, contact a
SoftBank Shop.
・Do not insert a sharp object into Card Slot Cap gap,
Earphones-Microphone Jack or External Connection Jack.
・To maintain water and dust resistance, it is recommended
to replace Card Slot Cap every 2 years regardless of its
condition. Customer-requested Card Slot Cap replacement
incurs fees and requires handset submission. For details,
contact a SoftBank Shop or SoftBank Customer Support,
General Information .
Washing Handset
Wipe off dirt, sand, beverage, etc., gently with a cloth. Then
hold handset approximately 10 cm below faucet or shower
head and wash with low-pressure tap water (6 liters/min.
or lower) at room temperature (5
o
C - 35
o
C). Wash with your
hands, taking care not to open Card Slot Cap; do not use a
brush or sponge. Dry handset before use; after drying it well,
power on.
・Before washing handset, make sure that Card Slot Cap is
closed firmly.
・Do not use a washing machine or ultrasonic cleaner.
・Earphones-Microphone Jack and External Connection Jack
tend to accumulate dust, sand, etc.; rinse and dry them
completely before use. Any residue may cause malfunction,
burns or fire.
・Do not put a cotton swab, cloth, etc. into Earphones-
Microphone Jack or External Connection Jack; may affect
water resistance, causing malfunction.
Drying Handset
After exposing handset to water, be sure to dry Earpiece,
Volume Up/Down Key, Power Key, Shutter Key, Mic, Recorder
Mic, External Connection Jack, Speaker, and Earphones-
Microphone Jack.
Wipe handset surface with dry cloth
Holding handset firmly by its sides, shake it about 20 times
・When shaking handset, hold it firmly so as not to drop it.
Pat against dry cloth to remove moisture from openings and
grooves
・Water may be trapped in openings; pat against a dry cloth
to remove it.
Leave handset on dry cloth for approximately 2 - 3 hours at
room temperature
Cautions
When Removing Moisture
Do not put a cotton swab, cloth, etc. into openings; may
affect water and dust resistance.
After Drying Procedure
Do not use handset in wet conditions.
・Calls may fail, or moisture may transfer to clothes, bag,
etc.
・Moisture may short-circuit Earphones-Microphone Jack,
External Connection Jack or other parts.
・Exposure to cold may freeze moisture and cause
malfunction.