Rise
™
Installation Guide 27
3
Drill a hole (minimum ø28mm, maximum ø40mm) through the ceiling and the noggin.
4
Remove the fixing bracket carefully from the fixed head arm.
5
Set the fixing bracket into position and mark the fixing points.
Remove the bracket and drill and prepare suitable fixings. Refit
the fixing bracket and secure it through the ceiling and into the
noggin using the screws provided, (if suitable).
6
Feed the arm through the fixing bracket to the correct depth.
Tighten the nut using a 32mm spanner if necessary to facilitate.
7
Cut off the excess pipe allowing for a suitable working length to allow for the required 22mm
connection. If a push fit connector is to be used then the pipe must be abraded to remove all
chrome plating.
8
Connect the pipe work from the Quartz
Smart Valve
™
/diverter to the end of the fixed head
pipe using a suitable coupling. Fully tighten the nut on the ceiling mounting bracket using a
32mm spanner if necessary to facilitate.
Run the shower for a few seconds to clear any debris and to check for any leaks.
•
!
9
Lubricate the ‘O’ ring if necessary and carefully slide the
cover plate back over the fixed head arm and into position
against the ceiling.
