Rise
™
Installation Guide 13
If installing this Rise
™
product as a replacement product, it may be necessary to purchase a
concealed retro-fit wall plate to cover the existing hole in the tiling.
The cavity in the wall should be plugged using a suitable material for the wall plate to be
secured to. Contact our Customer Service Department to purchase product code:
QZD.B3.RWP.14 – Concealed retro-fit wall plate.
9
Drill and prepare the four wall fixings for the controller using the fixings provided, (if suitable).
10
Feed the controller connection end of the data cable through the
centre hole in the mounting plate. Run a bead of silicone sealant
in the mastic groove on the back of the mounting plate and press
into position on the finished wall surface. Ensure the data cable
is held securely by the narrow middle slot of the mounting plate
and fix to the wall using the brass screws provided.
11
Plug the data cable into the rear of the controller and push fully home.
Slide the controller onto the mounting plate.
12
Secure the controller onto the mounting plate with the
fixing screw located at the base of the controller using
a small Pozidriv screwdriver.
To ensure a watertight seal, we recommend running a thin bead
of silicone around the concealed controller once it has been
secured to the mounting plate.
•
!
If you have an exposed system continue with instructions 13-24.
If you have a concealed system proceed to instruction 25.
13
Locate a suitable entry point into the ceiling for the riser rail, avoiding joists and services.
The centre of the riser rail stands 45mm from the wall. If this is not suitable, the spacers
provided with the fixing brackets will increase the depth to 70mm from the wall.
•
!
