Rise
™
Installation Guide 24
1
Run a 15mm outlet pipe from the Quartz
Smart Valve
™
/diverter to the preferred position for
the fixed head.
2
Cut the outlet pipe to the finished length (55mm – 150mm measured from the finished
wall surface) using a rotary type cutter. If a hacksaw is used, the pipe end must be carefully
de-burred and chamfered.
Slide the wall spacer down the projecting pipe flush with the finished wall surface.
3
Slide the 15mm gripper ring down the projecting pipe flush with
the wall spacer fitting.
4
Ensure the pipe is clean and free of dust and slide the fixing bush
onto the pipe flush with the finished wall surface.
5
Slide the fixed head arm over the fixing bush flush with the wall surface and mark the four
fixing points.
6
Carefully remove the fixed head arm and drill and prepare using the fixings provided, if
suitable, taking care to avoid pipework hidden in the wall.
7
Ensure the fixing bush is clean and free of dust, fit the 15mm ‘O’
ring against the end of the fixing bush. Lubricate the ‘O’ ring
using a suitable silicone based lubricant.
The ‘O’ ring must be positioned on the 15mm pipe flush to the fixing bush, not onto the
fixing bush shaft.
•
!
