17
2
Arrange the pipework so that the hot water is connected from the
left to the inlet marked ‘H’ and the cold from the right to the inlet
marked ‘C’, on the valve body.
For single outlet: The outlet pipe connects to the top of the valve
body.
For dual outlet: The fixed head or bath fill outlet pipe connects to the
left outlet (Outlet 1) on the valve body.
The adjustable head or hand shower outlet pipe connects to the right
outlet (Outlet 2) on the valve body.
For triple outlet: The fixed head outlet pipe connects to the left
outlet (Outlet 1) on the valve body. The adjustable head outlet pipe
connects to the right outlet (Outlet 2) on the valve body. The bath
fill outlet pipe connects to the bottom outlet (Outlet 3) on the valve
body.
For all models: Ensure sufficient pipe length; the pipe ends insert
into the valve inlets and outlet(s) a minimum of 10mm.
3
Connect the valve loosely to the pipework, do not tighten.
4
Hold the valve in position inside the cavity and mark the screw holes.
If required, disconnect the valve, drill the holes and insert the wall
plugs.
5
Connect the valve body to the pipework using the copper olives and
compression nuts provided, but do not tighten.
6
Secure the valve body with the wall screws.
7
Tighten the compression nuts to create a watertight seal.
