Aquaavia SWIMSPA, User And Installation Manual

Page: 17 / 34

User’s and installation manual SWIMSPA – FITNESS POOL English
41902E 18 EN-V00
screen. If you press “ Mode/Prog ” the spa will
go to the economy mode directly.
In
Sleep mode the pool functions as in the
Economy mode but the temperature set point
is automatically set back 10°C (if you set 30°C
the pool will only heat to 20°C) This is
normally to be used at times when there is low
usage of the pool such as winterizing the pool.
We recommend that you run the system in
“ Standard” or “ Economy” modes during
normal usage.
Mode adjustment: “
Standard ”/ “ Economy ” o
“ Sleep ”
When the spa starts for the first time you will
have to fit the time and the filtration cycles
before being able to choose the different
modes of operation (view previous section).
Your spa will begin automatically in
"Standard" mode.
To program the mode of operation, press
"Mode/Prog" . Press "Cool" to define the
operation mode desired (the screen will blink),
to confirm the selection press
"Mode/Prog" .
OPERATION OF JETSTREAM SYSTEM
Main control panel
Activation of Swim Jets
Press “ Jets 1 ” and “ Jets 2 ” buttons of the main
panel to start the counter-current swim jets.
Air turbulence can be adjusted by use of the
Venturi air control indicated by
“B” in the
picture of spa controls.
Swimspa counter currents
Jet strength adjustment
Power can be adjusted by using the two
diversion valves immediately above your jet
stream jets (“A” and “F” in the picture). Power
can be diverted to the spa massage section.
For full power the diversion of power must be
fully to the jetstream jets.
Jet direction adjustment
Each Counter Current can be individually
directed. First turn off the jets then by holding
the nozzle move the jets up, down, left or
right to give you a balanced counter current to
swim against.
OPERATION OF MASSAGE SYSTEM SPA
SECTION
Diverting flow to your spa section
On the diagram below you can see the two
diversion valves fitted to your system. By
turning the valves in the direction shown you
will divert power form the jet stream system to
the spa massage seats. The power diversion is
progressive and you can set any power to jet
stream– massage section combination you
would like.
ATTENTION: Do not turn the diversion
valves whilst the pumps are running.
Damage to the system may occur if you do.
Please, stop
“Jets1” and “Jets2” before
turning diversion valves.
Left hand side diversion valve “A” Right hand side diversion valve “F”
Diversion valves