User’s and installation manual SWIMSPA – FITNESS POOL
English
41902E 11 EN-V00
We strongly recommend that a suitable seal
cable guide is installed to retain the water
tight seal of the control boxes.
The incoming power line must be suitably
fused and protected to a C.E. minimum
standard and any local specific regulations
required.
PANEL MODEL GL2000M3
Single line (1 x 32 A):
Attention: the indicated blue cable is neutral,
and the brown cable indicates the line or
phase.
Three-phase line:
Attention: the indicated blue cable is neutral,
and the brown cable indicates the line or
phase.
IMPORTANT: The system should include a
neutral cable with line voltage to neutral of
230 V, A.C.
Fully remove the J26 and J32 cable.
Note: J32 and J23 are identical from an
electrical point of view. The cable can be
connected to either of these two terminals
before being removed.
Fully remove the J28 and J57 cable.
Note: J57, J58 and J59 are identical from an
electrical point of view. The cable can be
connected to either of these two terminals
before being removed.
Remove the J23 or J32 cable (see note above)
and connect it to J28.
HIGHAMP / LOWAMP GL2000M3
LOW AMP:
This configuration disconnects the
electric heater when a massage pump is
turned on. With this configuration, the electric
power is restricted.
NOTA:
LOW AMP is the factory default
configuration.
HIGH AMP:
This configuration enables all the
Spa elements to work at the same time. This
configuration requires a higher electric power
installation.
Change from LOW AMP / HIGH AMP
configuration using the switches in the
electrical box panel.
IMPORTANT: HIGH AMP configuration is
only available in Three-phase line mode.
LOW AMP: switch A2 must be OFF (factory
default configuration.)
HIGH AMP: switch A2 must be ON
Note: The following diagram
only shows the
position of switch A2
as a guideline ant it is
not necessarily the correct configuration of
your electrical control panel.
The manufacturer shall not be responsible
for any damage caused by an improper
installation or an installation performed by
non-qualified personnel.
Summary of Contents for SWIMSPA
Page 1: ......
Page 2: ...SPECIFICATIONS ESPECIFICACIONES SPEZIFIKATIONEN SPÉCIFICATIONS CARATTERISTICHE SPECIFICAÇÔES ...
Page 33: ......
Page 34: ......
