AQUASTREAM ULTIMATE
●
Speed signal permanently on: Speed signal is always generated regardless
of alarm events.
●
Power switch (53217): This mode can be used for emergency shutdown of
the PC, if the “RPM” header is connected to the power switch header of the
motherboard using a suitable cable (art. 53217). Before connecting the ca-
ble, make sure the pump is configured correctly! After connecting the cable,
test the setup by deliberately creating an alarm condition. If the PC is not
shut down, the cable header connected to the motherboard must be rotated
by 180 degrees and the test has to be repeated. Emergency shutdown may
result in data loss as operating system and running programs are not shut
down properly!
13.3.
13.3.
13.3.
13.3. Alarm reporting and alarm limits
Alarm reporting and alarm limits
Alarm reporting and alarm limits
Alarm reporting and alarm limits
Select the data sources to be monitored and set appropriate alarm limits. If the
current reading is below the limit (flow sensors) or higher than the limit (tempera-
ture sensors) or no fan speed signal is detected, an alarm will be raised if the
check box “Activate alarm evaluation” is set for this value.
While an alarm condition is detected, the pump display will permanently show a
corresponding information screen. If more than one alarm is active, the displayed
information will alternate between corresponding screens in short order. To
change the alarm configuration, you may still access the menu during alarm con-
ditions by pressing the middle key next to the display.
On the alarm page within the aquasuite, all sources that currently raise an alarm
are highlighted with a red background color. Alarms that have been active at least
once since pump start-up, but are not active presently, are highlighted with a yel-
low background color.
Make sure only to use readings for alarm evaluation that are functional with your
specific setup.
13.4.
13.4.
13.4.
13.4. System alarms
System alarms
System alarms
System alarms
System alarms are raised for severe malfunctions and can not be configured. If a
If a
If a
If a
system alarm is detected, the water cooling system will be either inoperational or
system alarm is detected, the water cooling system will be either inoperational or
system alarm is detected, the water cooling system will be either inoperational or
system alarm is detected, the water cooling system will be either inoperational or
severely impaired, instant action (shutdown of the PC) is mandatory!
severely impaired, instant action (shutdown of the PC) is mandatory!
severely impaired, instant action (shutdown of the PC) is mandatory!
severely impaired, instant action (shutdown of the PC) is mandatory! The alarm
buzzer is activated whenever a system alarm is detected.
The following system alarms can be detected:
●
Supply voltage too high: Pump function deactivated, fan output deactivated.
Shut down PC immediately!
Shut down PC immediately!
Shut down PC immediately!
Shut down PC immediately!
●
Supply voltage too low: Pump operational with reduced power, fan output
deactivated. Shut down PC immediately if fan output is required!
Shut down PC immediately if fan output is required!
Shut down PC immediately if fan output is required!
Shut down PC immediately if fan output is required!
●
Pump current too high: Pump function deactivated. Shut down PC immedi
Shut down PC immedi
Shut down PC immedi
Shut down PC immedi----
ately!
ately!
ately!
ately!
●
Pump current too low: Pump function deactivated. Shut down PC immedi
Shut down PC immedi
Shut down PC immedi
Shut down PC immedi----
ately!
ately!
ately!
ately!
- 20 -
Aqua Computer GmbH & Co. KG
© 2016-2018
Gelliehäuser Str. 1, 37130 Gleichen
computer
aqua
