SECTION 8: AUTO SEQEUNCE PROGRAMMING EXAMPLES
Entire Contents Copyright
2014 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
42L Series Modular DC Load Operation ManualPage 76 of 88
This completes the programming sequence.
8.3
Test Mode
To execute a previously stored auto-test sequence, proceed as follows:
1.
Press the TEST key on the mainframe to enter the TEST mode.
2.
Use the numbered STATE keys (1 to 9) to select the previously saved auto-sequence.
3.
Press ENTER to start the auto-sequence.
4.
The LCD shows “PASS” or “FAIL” after testing.
If limits and the NG functions have been set and a test step fails, the mainframe LCD
display will flash “NG”. The user must then press ENTER to continue the auto-
sequence execution or EXIT to abort the auto-sequence.
5.
Press auto-sequence or EXIT at any time to abort an auto-test sequence.
