APRILIA SR 125 - 1999, Manual

Page: 75 / 98

75 use and maintenance SR 50 - SR 125 - SR 150
#(!.').'
4(% 2%!2 ,)'(4 "5,"
Carefully read p. 70 (BULBS).
NOTE
Before changing a bulb, check
the fuse, see p. 69 (CHANGING THE FUS-
ES) and the effective operation of the stop-
light switches, see p. 61 (CHECKING THE
SWITCHES).
The rear light comprises two units. Each
unit contains:
– one parking light bulb (1);
– one stoplight bulb (2).
To change them, proceed as follows:
◆
Position the vehicle on the stand.
◆
Unscrew and remove the screw (3).
NOTE
While removing the protection
screen, proceed carefully in order not to
break the cog.
◆
Remove the protection screen (4).
◆
For the stoplight bulb (2) only, slightly
press the bulb and rotate it anticlock-
wise.
◆
Remove the bulb from its seat.
NOTE
Insert the bulb in the socket, mak-
ing the two bulb pins coincide with the rele-
vant guides on the socket.
◆
Correctly install a new bulb of the same
type.
a
CAUTION
Upon reassembly, correctly position the
protection screen in its seat.
Tighten the screw (3) carefully, without
exerting too much pressure, in order to
avoid damaging the protection screen.
#(!.').'
4(% .5-"%2 0,!4% "5,"
Carefully read p. 70 (BULBS).
To change the bulb:
a
CAUTION
Do not pull the electric wires to extract
the bulb socket.
◆
Grasp the bulb socket (5) from the inside
of the rear part of the fairing cover, pull it
and remove it from its seat.
◆
Withdraw the bulb (6) and replace it with
a new one of the same type.