APRILIA SR 125 - 1999, Manual

Page: 35 / 98

35 use and maintenance SR 50 - SR 125 - SR 150
).3425#4)/.3 &/2 53%
a
WARNING
Before departure, always carry out a
preliminary checking of the vehicle, to
make sure that it functions correctly
and safely, see the following table PRE-
LIMINARY CHECKING OPERATIONS.
The non-performance of these checking
operations can cause severe personal
injuries or damages to the vehicle.
Do not hesitate to consult your
APRILIA
Official Dealer in case there is some-
thing you do not understand about the
functioning of some controls or in case
you suspect or discover some irregular-
ities.
It does not take long to carry out a
check-up and this operation ensures
you much more safety.
02%,)-).!29 #(%#+).' /0%2!4)/.3
Component Check Page
Disc brakes Check the functioning, the fluid level and make sure
there are no leaks.
Check the wear of the pads. Top up, if necessary.
27, 28, 51
Rear drum brake
3
Check the functioning, the idle stroke and the control
lever conditions. If the clearance is not correct, adjust it
.
29, 51
Accelerator Make sure that it works smoothly and that it is possible to
open and close it completely, in all steering positions.
If necessary, adjust and/or lubricate it.
63
2 stroke oil Check and/or top up, if necessary. 26
Wheel / tyres Check the tyre surface, the inflation pressure, wear and
tear and any damage.
32 ,33
Brake levers Make sure that they work smoothly.
If necessary, lubricate the articulations.
27, 28, 29
Steering Make sure that the steering rotates smoothly, without any
clearance or slackening.
52
Centre stand Make sure that they work smoothly and that the spring
tension brings it back to its normal position.
If necessary, lubricate joints and hinges.
61
Fastening elements Make sure that the fastening elements are not loose.
If necessary, adjust or tighten them.
—
Fuel tank Check the fuel level and top up, if necessary.
Make sure there are no leaks or occlusions in the circuit.
25
Coolant
1
The coolant level in the expansion tank must be included
between the
“
MIN
”
and
“
MAX
”
markings.
Top up, if necessary.
30, 31
Engine stop switch
(
n
-
m
) ( in the
countries where
required)
Make sure that it functions correctly.
19
Lights, warning
lights, horn and
electric devices Check the proper functioning of all the devices.
Change the bulbs or intervene in case of failure.
65 – 75