Installation and Service Manual – Metered Carbon Filter
Page 2
Copyright © 2012 Applied Membranes, Inc. All Rights Reserved.
Valve Operation Quick Reference Guide
General Operation
When the system is operating one of two displays will be
shown. Pressing NEXT will alternate between the
displays. One of the displays is the current time of day.
The second display is one of the following: days remaining
or gallons remaining.
If the system has called for a regeneration that will occur
“tonight”, the words REGEN TODAY will appear on the
display. When water is flowing through the system the
word “FILTERING” flashes on the display.
Set Time of Day
In the event of a prolonged power
outage, time of day flashes,
indicating that it needs to be reset.
All other information will be stored
in memory no matter how long the
power outage. Please complete
the steps as shown to the right.
1.
Step 1U:
Press SET CLOCK
2.
Step 2U:
Current Time (hour): Set the hour of the
day using
▲
or
▼
buttons. AM/PM toggles after 12.
Press NEXT to go to step 3&U
3.
Step 3U:
Current Time (minutes): Set the minutes
of the day using
▲
or
▼
buttons.
Press NEXT to exit Set Clock.
Press REGEN to return to previous step.
Manual Regeneration
To initiate a generation at the preset delayed
regeneration time of day:
Press and release “REGEN”.
The words “REGEN TODAY” will flash on the display. If
the “REGEN” button was pressed in error, pressing again
will cancel the request.
To initiate manual regeneration immediately:
Press and
hold “REGEN” button for three seconds. System will begin
regeneration immediately. Request cannot be cancelled.
“REGEN TODAY” will flash if a regeneration is expected “Tonight”.
The control valve may be stepped through the various regeneration cycles by pressing the “REGEN” button.
Regeneration Mode
When the filter begins to regenerate, the display will change to include information
about the step of the regeneration process and the time remaining for that step to be
completed. The system runs through the steps automatically and will reset itself to
provide treated water when the regeneration has been completed.
Error Message
If the word “ERROR” and a number are alternately flashing
on the display, check the trouble shooting section of this
manual to identify the error.