Page 31 of 60
14.3 Call Program
This program can execute the created program in the other program.
Also, the number of the interval for Call program operation can be set.
Using JOG key to move iron cartridge until “Call Program”
point.”
Press ENTER .
Select the type “Call Program” by CURSOR key.
*Page 2 is displayed by SHIFT + ↓ key.
Press ENTER .
Enter the desired program number.
Press ENTER .
Enter the interval number. (Initial value: 1)
Press ENTER .
The count is updated at the end of one cycle (No display),
also it is updated when the program is stopped on the way
such as error.
Aftre power on, emergency stop or after opreation mode is
switched, Call Program is always carried out in the 1st cycle.
The count is cleared after power-off or operation mode is
switched.
e.g) Cleaning interval is “3”.
The three cycles end, then Call Program is carried out at the 4th cycle.
The 4th cycle is counted as one cycle, so the next Call Program is carried out at 7th cycle.
Enter a number
Program Number 103
Program1
P1
X 0mm
Y 0mm
Z 0mm
R
0deg
FUNC JOG MDI
INIT
Select Point Type 2/4
Cleaning Start Point
Cleaning End Point
Sponge Cleaning (CW)
Sponge Cleaning (CCW)
Start of Sponge Cleaning
End of Sponge Cleaning
Brush Cleaning
Start of Brush Cleaning
End of Brush Cleaning
Call Program
PTP Point
PTP Evasion Point
Enter a number
Call Interval
1
