Page 11 of 60
5. Preparation
Set Solder Wire
1) Remove the feed tube and pull solder wire through
first. Then attach the solder tube.
2) Set the solder wire as per the diagram, and make
sure to set solder wire on top of the solder shortage
senseor arm.
3) If the release lever is upper position, the cutting
blade/pinch roller will not feed the solder wire. When
ready to feed the wire, put the leaver in the “down”
position.
4.2 How to Adjust RSP Iron Unit
4) Solder wire feeding position can be adjusted.
Upper adjusting screw
:
Up/down direction
Lower adjusting screw
: Left/right direction
5) Iron up down speed can be adjusted by turning screws
after loosening the locking nut.
Upper black screw
: Iron Up Speed
Lower white screw
: Iron Down Speed
6) Second solder feeding position can be altered
by moving this screw. Using this adjustment screw, solder
can be prefed under the tip then fed into the joint with the
iron down.
Lowering the screw position:
Decreases the distance the Iron moves for second
feed.
Rasing the screw position:
Increases the distance the iron moves for second feed.
(1)
(3)
(2)
