Anywave MPTV, User Manual

Page: 30 / 96

MPTV V1 TX User Manual
MPTV-V1-1KW-USR-DOC-V1.0, 05/25/2018 Page 30 of 96
RF submenu while watching the Sys FWD power increase accordingly on the
Controller touchscreen.
Begin to slowly raise the FWD System power by using the UP button on the Exciter,
while monitoring the FWD system power meter on the Controller HOME screen as
shown below.
4. Slowly bring the FWD power to ~ half-power and notice the power meter values of
REFL, REJCT, and VSWR to be sure these look reasonable (less than the values of
the TX operating at a full rated power (please reference your Factory Test Report
for these values).
Check to be sure that the lower left corner of the HOME screen shows the status as
“RUNNING OK!” and there are no alarm messages. If you do see an alarm message,
please reference the Troubleshooting section of your transmitter User Manual to
understand what the error means and suggested steps to correct it. (For example, when
initially turning on a system, the error message AMP_VSWR_ERR (accompanied by
high REFL power readings) may be witnessed - indicating a connection problem
somewhere in the external RF System – a mismatch sending hi reflected energy back
to the REFL sample on the output directional coupler inside the TX cabinet.)
5. Continue to slowly raise the FWD power until you reach the max power rating of
the TX, or your lower desired TPO. Check to be sure that the PA device currents do
not exceed the full power operating currents as shown in your Factory Test Report.
Slowly increase to
raise FWD SYS
POWER
Monitor FWD
SYS POWER
Monitor REFL,
REJT, and VSWR