Anywave MPTV, User Manual

Page: 20 / 96

MPTV V1 TX User Manual
MPTV-V1-1KW-USR-DOC-V1.0, 05/25/2018 Page 20 of 96
2.1 Control Unit
TX Control Unit CTL-S-V1 consists of a pre-amp, and a powerful control
system. It receives the RF input(s) from the exciter(s), performs the pre-amplification,
and sends RF output to a PA or an external 2-way splitter to feed 2 PAs. The CTL-S-
V1 communicates over an RS-485 serial bus to the PAs and Exciter(s) installed in the
system and monitors system Forward, Reflected, and Reject load power.
Front panel
The front panel of Control Unit is shown below.

Color touch screen

LED_OK

If the green light is ON, then the transmitter is working in OK mode.

LED_ALARM

If there is any alarm, the red light is ON, and the transmitter will shut down its
output. The most common alarms include: Over-drive/over-current of PA
modules or Preamp, high reflected power of PA modules or Preamp, high
absorbed power, over temperature of PA modules or Preamp, etc. Please refer
to Status Bar and LOG from the touch screen of Control Unit for details.

RESET (reserved)