anvajo fluidlab R-300, User Manual, Page: 51 / 69

User Manual fluidlab R-300
52
Edition 202104
Vers.: 1.2
Changing the Test Name and Deleting Measurements
If, rather than just briefly tapping on a measurement, you maintain the contact between
your finger and the screen for several seconds (long press), you can carry out further
options (Figure 34). An editing menu appears in a green bar at the top of the screen,
containing a pencil, a rubbish bin and an arrow. You can use the pencil to change the
test name and the arrow to exit the editing menu. You can use the rubbish bin to delete
either a single measurement or multiple measurements, by tapping on the boxes on the
left-hand side of the relevant line(s).
If all measurements saved on the device should be deleted at the same time, the
“Delete history” button at the end of the History list can be used.
6.5 Quality Assurance
Figure 35: Maintenance options.
6.5.1 Sensor Status
Checking the sensor status is a quality control procedure for maintaining the fluidlab R-
300's measuring functionality and accuracy.
1. Open the settings menu of the fluidlab R-300 by tapping the menu icon
( ).
2. Tap on the menu item “Maintenance”.
3. Tap on the menu item “Sensor Status” ( Figure 35).
4. Tap on “Start Sensor Check” ( Figure 36).
5. After a few seconds, the result of the sensor check will appear.
6. If the status is “OK”, no further action is required. In all other cases, please
clean the sensor (see Chapter 8.5.3).
Warning!
The device can only be used for further measurements if the sensor status “OK” is
displayed. If the sensor status “OK” cannot be obtained even after repeated cleaning
of the sensor, the device may no longer be used. In this case, please contact the support
department (see Chapter 8.7).