6
Make sure that the red indicator light is on.
7. There is an intake hole in the back of the flightcase. There is a metal net and a filter attached on
the intake, which can prevent a clogging problem. Please inspect and clean the metal net and
filter periodically.
Caution
1.
Always monitor and make sure that there is sufficient haze liquid inside the tank during
operation.
2.
When the machine is operated for a longer period of time under open- air conditions,
falling dust/debris might attach to the metal net and filter on the intake hole. The metal net
and filter is serviceable, which means those can be detached easily by a screw driver.
Please use water to clean the metal net and filter periodically. By doing this
you can
avoid dust going into the hazers and prevent the clogging problem of hazers.
3.
If you have followed the above operation steps, and you still experience low output,
mechanical noise or no output at all, unplug the unit immediately from the mains. Check the
fluid level, the external fuse, the remote control connection, and the power cable from the wall.
If all of the above appears to be OK, plug the unit in again. If the hazer still does not function,
discontinue operation or it may result in permanent damage to the unit. Return the machine to
your Antari dealer. Always drain tank before mailing or transporting this unit.
4. Please detach the cap on the tank if you want to clean the cap.
Do not wipe it directly when the cap is attached on the tank. By doing this you can avoid letting
dust fall into the fluid tank and contaminate the haze liquids.
5.
lease do not allow magnetic equipment to be close to the haze outlet door of the hazer. Magnetic
equipment could cause wrong action of the door sensor.
Control Panel Operation
The built-in control panel on the rear of the machine features an LCD panel displaying all operation
statuses of the haze machine. The control panel allows the user to customize functions by adjusting the
fogging duration and interval as well as the DMX address and the door sensor. There are six buttons on
the control board. All current operating parameters are automatically stored in a non-volatile memory,
