8
3.
Setting the DMX512 address
Press the FUNCTION until the display indicates »DMX 512«. Use the buttons UP and DOWN, to set the
machine to the same address as on your DMX controller. Please refer to chapter DMX512 settings for
more information on DMX operation.
4.
Switching the door sensor on and off
Press the button FUNCTION until the display indicates »DOOR ON SENSOR«. Press the button
MANUAL to deactivate the door sensor (indication » DOOR OFF SENSOR «) and the button VOLUME to
reactivate it. Please see *Note 2.
5.
Direct haze
Press the button FUNCTION until the display indicates »Direct Haze«. Press the button MANUAL to
activate the direct haze mode. Then the machine directly starts producing haze after switching on the
power. The display indicates »Direct Haze« and starts flashing. To stop the haze output, shortly press
the button MANUAL again. The display stops flashing.
*
Note 1:
The control of the master unit will override the control of the panel controller when
connecting the haze machine via DMX.
*
Note 2:
If the haze outlet door sensor is activated (indication »DOOR ON SENSOR«), a warning
sound will beep when haze output is activated and the door is not completely open. The
flashes and indicates »DOOR CLOSED!!«. The haze production stops until the door is
completely opened. If the door sensor is not activated (indication »DOOR OFF SENSOR«),
this safety features will not occur.
*Note 3:
If the displays shows »Out Of Order«, the machine's internal temperature is too high and
as a result the thermostat has been set off to shut-down the hazer.
If you experience this problem, please check two points as described below:
1.
Check if the mesh (filter) outside the ventilation fan is clean and without debris. If the
mesh is covered by dust or obstruction (such as paper, plastic bag, etc.), the machine
is put into a very poor ventilation condition and causes the internal temperature to rise.
Therefore, it is strongly suggested to clean the mesh regularly.
2.
Check the surrounding temperature at the hazer's place of installation. If the
temperature of the surrounding environment is too high, please move the machine to a
cooler place with better ventilation.
*Note 4:
Before moving the machine, it is important to replace the nozzle by the black rubber stopper.
Please make sure it fits tightly in order to prevent spillage of the HZL-1 Haze liquid in case
the machine is turned upside down during the transportation. Before reusing the machine,
