Anritsu Site Master S330A, User Manual, Page: 66 / 85

2 - 50
Chapter 2 Operation
Error Message Description
DIST REQUIRES
F1 < F2 Valid distance to fault plots require a non-
zero frequency span.
DIST REQUIRES
CAL Distance-to-fault measurements do not pro-
vide usable data with CAL OFF.
NO STORED
SWEEP AT THIS
LOCATION
Attempting to recall a display from a loca-
tion that has not been previously written to.
That is, the location does not contain stored
sweep.
USE OPTIONS
MENU TO
SELECT A
PRINTER Attempting to print a display with no printer
selected. Select a printer, then retry.
DISTANCE AND
CABLE
INSERTION LOSS
MODE ARE
INCOMPATIBLE DTF measurements only display RL or
SWR versus distance.
CANNOT ZERO
NO DETECTOR
INSTALLED Attempting to perform a Power Monitor
zero adjust function with no RF detector
connected to the Site Master.
CANNOT ZERO
INPUT SIGNAL
TOO HIGH Attempting to perform a Power Monitor
zero adjust function with an input of greater
than –20 dBm.
POWER MONITOR
OPTION NOT
INSTALLED Attempting to enter Power Monitor mode
with no option 5 installed.
Table 2-3.
Range Error Messages (2 of 2)