Anritsu Site Master S330A, User Manual, Page: 19 / 85

ESCAPE/CLEAR
key is held down, the factory pre-
set state is restored.
PRINT
Prints the current display to the selected printer.
RECALL
DISPLAY Recalls a previously saved trace from memory loca-
tion 1 through 40. When the key is pressed, “Recall
display:” appears on the display. Select an appropri-
ate number from the keypad and press the
ENTER
key to implement.
RECALL
SETUP Recalls a previously saved setup from memory loca-
tion 0 through 9. When the key is pressed, “Recall
Setup:” appears on the display. Select an appropriate
number from the keypad and press the
ENTER
key
to implement. Setup 0 recalls the factory preset state.
RUN
HOLD
When in the Hold mode, this key starts the Site Mas-
ter sweeping and provides a Single Sweep Mode
trigger; when in the Run mode, it pauses the sweep.
When in the Hold mode, the hold symbol (Table 2-1,
page 2-47) appears on the left side of the LCD.
(HOLD conserves considerable battery power.)
SAVE
DISPLAY Saves the displayed trace to 1 of 40 internal
non-volatile memory locations. When the key is
pressed, “Save display:” appears on the display. Se-
lect an appropriate number from the keypad and press
the
ENTER
key to implement.
To erase saved displays select 0 and press
ENTER
.
Individual displays may be selected and erased by en-
tering the display number and pressing
ENTER . Se-
lecting display 0 will erase all saved displays.
2 - 3
Chapter 2 Operation