Anritsu MG369 Series, Operation Manual

Page: 147 / 268

Stepped Delay Mode
The Stepped Delay Mode lets you automatically in-
crement or decrement the Pulse Delay 1 (D1) value
according to step delay parameters. The mode is
only available when the Delayed or Triggered w/de-
lay triggering mode is selected. Selecting either trig-
gering mode adds the soft-key
Step Delay >
to the
Internal Pulse Status menu. Refer to page 3-110 for
setting the triggering options.
From the Internal Pulse menu, press
Step Delay >
to access the Step Delay Mode menu (below).
This menu allows you to perform the following:
q Turn step delay on/off
q Edit the step delay parameters
q Set the length of time a Delay 1 (D1) time is
applied before it is incremented or decrement-
ed by the step size
Open the parameter you wish to change, then edit
the current value using the cursor control keys or
the rotary data knob or enter a new value using the
key pad and appropriate termination key. When you
have finished setting the open parameter, close it by
pressing its menu soft-key or make another menu
selection.
Press
On/Off
to turn the Stepped Delay Mode on
and off.
Press
Start Delay
to open the Delay 1 (D1) start
time parameter.
Press
Stop Delay
to open the Delay 1 (D1) end time
parameter.
MG369XB OM 3-113
Local (Front Panel) Operation Signal Modulation
NOTE
If the set Step Delay parameters re-
sult in a fractional number of incre-
ments, then the last (fractional) one
is not taken.