Anritsu MG369 Series, Operation Manual

Page: 142 / 268

Press
Edit Period
to open the Pulse Period parame-
ter. (If you had selected PRF instead of Period at the
Internal Pulse Configuration menu, the soft-key
would read
Edit PRF
and pressing it would open
the PRF parameter.) Edit the current value using
the cursor control keys, rotary data knob, or enter a
new value using the keypad and the appropriate
terminator key. To close the Pulse Period parameter,
press
Edit Period
(or
Edit PRF
) or make another
menu selection.
Press
Wdth / Dly List...
to display the Pulse
Width/Delay List menu (below) of current Pulse
Width (W1-W4) and Delay (D1-D4) parameter
settings.
To change the current value of a parameter, use the
cursor control keys to select the parameter, then
press
Edit Selected
. Edit the current value using
the cursor control keys, rotary data knob, or enter a
new value using the keypad and the appropriate
terminator key. To close the open parameter, press
Edit Selected
or
< Previous
.
When the Delayed or Triggered w/delay trigger
mode is selected, the menu display adds the soft-key
Step Delay
. This soft-key lets you access menus for
setting the step delay parameters and turning the
Stepped Delay Mode on and off. The Stepped Delay
Mode is described on page 3-113.
3-108 MG369XB OM
Signal Modulation Local (Front Panel) Operation
NOTE
At a 100 MHz pulse clock rate, the
pulse period must be 50 ns longer
than the pulse delays; at a
40 MHz pulse clock rate, the pulse
period must be 125 ns longer than
the pulse delays; at a
10 MHz pulse clock rate, the pulse
period must be 500 ns longer than
the pulse delays.
NOTE
Pulse Delay (D1) is only active
when Delayed or Triggered w/delay
triggering mode is selected.