Anritsu 37 C Series, Operation Manual

Page: 438 / 603

37XXXC OM A-103
ALPHABETICAL LISTING G
MENU DESCRIPTION GPIB COMMAND
SELECT
GRAPH TYPE None
LOG MAGNITUDE Selects a log magnitude graph for display on the active
channel's selected S-parameter. The active channel is indi-
cated by its key (CH1, CH2, CH3, CH4) being lit. MAG
PHASE Selects a phase graph for display on the active channel. PHA
LOG MAGNITUDE
AND PHASE Selects log magnitude and phase graphs for display on the
active channel. MPH
SMITH CHART
(IMPEDANCE) Selects a Smith chart for display on the active channel. SMI; SME; SMC
SWR Selects an SWR display for the active channel. SWR
GROUP DELAY Selects a Group Delay display for the active channel. DLA
POWER OUT Provides for measuring output power. The measurement of
output power is accomplished by using the b2 (or Tb) mea-
sured value normalized to the power supplied to the AUT at
Test Port 1. While the b2 parameter is the most meaning-
ful for this graph type, you may use any other parameter. POW
MORE Calls additional graph type selections on menu GT2. None
PRESS <ENTER>
TO SELECT
AND RESUME CAL
Pressing the Enter key implements your menu selection
(and resumes the calibration from where it left off, if in the
calibration mode). None
Menu GT1/CAL_GT1, Select Graph Type