Anritsu 37 C Series, Operation Manual

Page: 325 / 603

15-3
INSTALLATION This section describes installation and system check-out without mak-
ing use of a wafer-probe test station. For instructions on installation of
the wafer probe test station, refer to paragraph 15-5.
Important Notes:
·
The empty console weighs approximately 66kg (145
pounds). Use two people to remove the console from the
pallet.
·
Many of the instruments are quite heavy and require
two people to lift them.
·
Instruments should be loaded into the bottom sections of
the console first, to prevent tipping of the console.
·
The VNA instrument has fragile RF cables connected to
both the front and rear panels. Be careful not to bend
these cables when handling the instrument.
·
If the synthesizers are not installed precisely as de-
scribed below, the system will be non-functional.
·
We suggest using an 8 in/lb torque wrench to tighten
SMA connectors (available in most Anritsu VNA Cali-
brations Kits) Do not tighten any connectors over 8
in/lbs.
Console and Table Setup Set up the console and table as described below.
Step 1. Remove the shipping container and all packaging
and accessories from around the console. Set the ta-
ble aside. Instructions for table installation appear
later.
Step 2. Lift or roll the console off the pallet (to lift: insert
two 4 to 6 foot long sections of “2x4” lumber through
the console top and lift it, using one person on each
side).
Step 3. Cut the tie wraps which are securing the table
mounting rails at the console rear door. Cut the tie
wraps which are securing the power cords and wrist
strap ground wire.
Step 4. Attach the mounting rails to the table as shown in
Figure 15-1.
INSTALLATION BROADBAND SYSTEM
15-4 37XXXC OM