Anritsu 37 C Series, Operation Manual

Page: 326 / 603

Instrument Installation
into Console
Refer to Figures 15-2, 15-3, and 15-4 for installation of major instru-
ments and cables.
Step 1. Check the rear panel serial number labels of the syn-
thesizers. The instrument without Option 15A be-
longs in the bottom compartment (“RF” synthesizer).
The GPIB address for this synthesizer should be set
to 5. This can be done by pressing SYSTEM, then se-
lecting CONFIG and GPIB ADDRESS.
Step 2. Install the synthesizer with Option 15A in the sec-
ond opening from the bottom. . This synthesizer
must be set to GPIB address 4 using the instructions
mentioned in the previous step.
Step 3. On the left front of the console, move the black
ground wire away from the guide of the table-mount-
ing rail, and install the table by sliding the table
rails into the guides.
Step 4. Secure the table rails at the rear of the console using
the screws provided.
Step 5. Install the VNA into the top compartment. Ensure
the three small RF cables are installed onto the front
and rear panels (one in front, and two in back).
Step 6. Install the 3738A Test Set into the compartment be-
low the VNA.
37XXXC OM 15-5
BROADBAND SYSTEM INSTALLATION
1 0 - 3 2 x 1 / 2 I N C H
# 1 0 L O C K W A S H E R
# 1 0 F L A T W A S H E R
I N S T A L L I N T W O P L A C E S A F T E R
P L A C I N G T H E W R I T I N G S U R F A C E
I N T O T H E C O N S O L E .
1 0 - 3 2 x 1 / 2 I N C H
# 1 0 L O C K W A S H E R
I N S T A L L I N 6 P L A C E S
Figure 15-1. Console Table