Angel Water PurAzone A03, Manual

Page: 11 / 34

10
SET
Step 1
Set Time of Day
= Up Arrow = Down Arrow
Step 1 - Press SET CLOCK.
SET TIME
SET TIME
6:35
PM
6:35
PM
Step 2
Step 3
Step 2 - Current Time (hour) : Set the hour of the day using or buttons.
AM/PM toggles after 12. Press NEXT to go to step 3.
Step 3
- Current Time
(minutes)
: Set the minutes of day using
or
buttons. Press NEXT to exit Set Clock. Press REGEN to return to previous
step.
Power Loss - Lithium battery on circuit board provides up to 2 years of
time clock backup during power outages. If the power is out when battery
is depleted, only time of day needs to be reset, all other values are stored
in non-volatile memory. When time of day is flashing, replace lithium coin
type 2032 battery.
Battery back-up feature will be activated after 24 hours of power.
RETURN TO ROTATING DISPLAY
Do not forget to reset for daylight savings time.
Installer Programming
Step 1I
= Up Arrow = Down Arrow
Step 1
I - Press NEXT and simultaneously for 3 seconds.
This display may not appear on standard filtering mode.
WATER HARDNESS Step 2I
Step 2 I - Hardness : Not Applicable (nA) Press NEXT to go to Step 3.
SET
NA
GR Step 3
I
- Day Override:
This sets the number of days between regenerations. If
value set to “oFF” regeneration initiation is based solely on gallons used. If value
is set as a number (allowable range from 1 to 28) a regeneration initiation will be
called for on that day even if sufficient number of gallons were not used to call
for a regeneration. Set Day Override using
or
buttons:
Factory setting is 1
day.
DAYS BETWEEN REGEN
SET
1
REGEN TIME HOUR
Step 3I
Step 4I
• number of days between regeneration (1 to 28); or
• “oFF”
Press NEXT to go to step 4. Press REGEN to return to previous step.
Step 4
I
- Regeneration Time (hour):
Set the hour of day for regeneration using
or buttons. AM/PM toggles after 12. The factory setting time is 12:00
a.m. This display will show REGEN IMMEDIATE ON ZERO GAL if system is set
for immediate regeneration. Press NEXT to go to step 5I. Press REGEN to return
SET
12:00
AM
to previous step.
Note: When installing this unit as part of a multi unit parallel system the regen
time of day must be adjusted to prevent multiple units from regenerating
at the
same time.
REGEN TIME MINUTES Step 5I
Step 5 I - Regeneration Time (minutes): Set the minutes of day for regeneration
SET
12:00
AM
using
or
buttons. This display will not be shown if system is set for immedi
-
ate regeneration. Press NEXT to exit Installer Displays/Settings. Press REGEN to
return to previous step.
RETURN TO
NORMAL MODE