Anatol VOLT, Operator'S Manual, Page: 6 / 68

A) Remove the VOLT indexer from the skid and all wrapping/packaging
material. Remove all blocking, screws, nails and/or strapping
materials from any components that were fastened or secured for
shipment.
B) A forklift with 6-8’ extended forks capable of lifting 5000 lbs. will be
required to unload the truck and remove the base from its skid. Spot
the base in the desired location, installing the adjustable base
supports (if not already installed) with the forklift. The base will be
leveled and the supports tightened by the installing technician.
*CAUTION: DO NOT REMOVE THE PRINT HEADS FROM THEIR
CRATE(S). This will be supervised by the installing technician.
Damage may be caused to the head keypad, screen holder
extrusion, and electrical cables. You may remove the top of the
head crate(s), but leave the print heads in the crate.
C) Have a qualified electrician supply the main enclosure disconnects
with the required voltage, according to NEC standards. (The serial
number tag on the electrical enclosure will provide electrical
requirement information). DO NOT USE electrical conduit as a
ground. A separate ground wire must be provided.
*SOME MACHINES WILL BE WIRED 115/120 VAC, 2A, 60Hz. – an
electrician will be required for this standard connection. However,
all Flash Units are at least 208-240VAC, either single or 3 phase
and should be connected by a qualified electrician.
1.2 Installation Requirements
anatol.com 6