ADM & Sub Aspida
User Manual
Int. Approved
Document ref: PSA-811-22
March 2020
Page 36 of 45
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
7]
Lift the extraction tool vertically away from the device and the oxygen sensor
should lift out of its socket as shown in Figure 31.
Figure 31
Removing the oxygen sensor
8]
Remove the old sensor from the extraction tool by gently pushing the sensor
from the wide, top end of the extraction tool, whilst not squeezing the grip.
THE SENSOR CONTAINS LEAD AND ACCORDING TO WEEE
REGULATION MUST NOT BE PLACED IN HOUSEHOLD WASTE
BINS. PLEASE CHECK LOCAL REGULATIONS FOR
INFORMATION ON THE DISPOSAL OF ELECTRONIC
PRODUCTS IN YOUR AREA.
9]
Remove the new sensor from its packaging. Oxygen sensors are supplied in
sealed bags. Before the bag is opened check that the sensor has not leaked
–
if it
has, then please refer to the safety information at the start of this section.
Figure 32
Insert the new sensor into the extraction tool
Summary of Contents for ADM Aspida
Page 2: ......
