ADM & Sub Aspida
User Manual
Int. Approved
Document ref: PSA-811-22
March 2020
Page 17 of 45
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
6.3
User registration
The Analox Aspida allows for registration of up to two usernames. This allows users to share use
of the device. On start-up, a username is selected, and all subsequent gas information is logged
internally against the selected user ID. Users can be registered to a device using the
Aspida
configuration software. See the
Aspida configuration software for instructions.
On device power up, if a single user is registered, the username will be displayed for a few
seconds, after which the device will operate normally.
If 2 users are registered, both usernames will be displayed in a menu for the user to select.
Pressing the
button will cycle between highlighted usernames. The
button will select the
highlighted user.
NOTE:
IF A USER IS NOT SELECTED WITHIN 2 MINUTES OF START-
UP, A ‘NO USER’
ID WILL BE SELECTED AUTOMATICALLY AND
THE DEVICE WILL PROCEED TO RUN NORMALLY. DURING
THESE TWO MINUTES, A REMINDER BEEP WILL BE SOUNDED
TO PROMPT THE USER TO SELECT AN ID.
6.4
The main display
Under normal operation, gas values for each of the sensors fitted are shown in their own window
along with the description of the gas type and measurement units. The current gas value for each
sensor will be updated on the display once per second.
Figure 3
Dual sensor display (left), single sensor display (right)
1)
Man-down detection enabled icon
2)
Clock
3)
Measured gas types (dual sensor)
4)
Measured gas values (dual
sensor)
5)
Measured gas units (dual sensor)
6)
Quiet mode enabled icon
7)
Atmospheric pressure (mbar)
8)
Battery status icon
9)
Measured gas type (single sensor)
10)
Measured gas value (single sensor)
11)
Measured gas units (single sensor)
NOTE:
THE ADM ASPIDA DOES NOT INCLUDE A PRESSURE SENSOR,
IT HAS A FIXED ATMOSPHERIC PRESSURE READING OF 1000
MBAR. THIS VALUE IS DISPLAYED AS ABOVE BUT WILL
REMAIN AT 1000 MBAR.
Summary of Contents for ADM Aspida
Page 2: ......
