29
IX. OPERATING GUIDE
u
SEAT - WIDTH ADJUSTMENT
Unscrew and remove the 6 to 8 screws located on top of the
seat pan with 3/16 Allen key and, then equally adjust the seat
width to the desired width and put screws back in place.
NOTE
- The width adjustment must also be made on the rear
cross tubes that hold the back canes and seat laterally. Use a
3/16" Allen key with 7/16" wrench to remove the 2 bolts.
!
WARNING
At all times, the screws holding the seat plates and back
cross tube must be screwed in tight and secured in order to
avoid severe injury and/or damage to the seating system.
!
WARNING
Make sure the wheelchair is on a level surface.
INCREASING & DECREASING
THE POWER CENTER MOUNT
4-way Toggle
Move the four-way toggle switch
towards the left side of the wheelchair
until the desired center mount angle
is achieved. To reverse the center
mount angle direction: release the
four-way toggle switch to the neutral
position for a minimum of 1 second
and move the four-way toggle switch
towards the left side of the wheelchair
until the desired center mount angle is
achieved.
Push Button Switches
Push the 3rd button until the desired
center mount angle is achieved and
release. To reverse the center mount
angle direction: release the 3rd
button to the neutral position for a
minimum of 1 second and push the
same button until the desired center
mount angle is achieved and release.
O. POWER ELEVATING FRONT RIGGINGS
(Standard Operating Instructions)
P. ADJUSTMENTS
3rd push
button switch
Summary of Contents for R HybridHybrid
Page 1: ...Rev 01 February 2017...
