AmySystems R HybridHybrid, Owner'S Manual

Page: 16 / 39

16
VIII. SET-UP
- ADJUSTMENT AND USE
NOTES:
1. Work Surface for Set-Up:
Use a flat surface, such as a table, to assemble, adjust
and check your chair. This makes the steps easier and
helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are
special high-strength fasteners and may have special
coatings.
• Many nuts are of the Nylon Insert Lock Nut type.
They have a plastic insert to help prevent loosening.
• Only use screws, bolts and nuts provided by
AmySystems.
!
WARNING
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause
damage to chair parts.
3. If bolts or screws become loose, tighten them as soon
as you can. Loose bolts or screws can cause damage
to other chair parts causing them to fail.
4. Washers & Spacers:
• Note the position of washers and spacers before
disassembly.
• To avoid damage to the frame, replace all washers
and spacers when you reassemble parts.
- TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you may need
the following tools:
• Phillips screw driver
• Metric wrenches from 10mm to 13mm
• Metric Allen wrenches from 3mm to 6mm
• Imperial wrenches from 1/4” to 9/16”
• Imperial Allen wrenches from 5/64” to 1/4”
• Imperial socket from 7/16” to 3/4”
• Ratchet
NOTE - These tools can be found in common hardware stores.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself,
AmySystems recommends that you use a torque wrench.
NOTE - The wrench must measure inch-pound or N-m. You
can buy a torque wrench and proper sockets from a hardware
store.
t
VIII. SET-UP