27
TIP-OVER LIMIT SWITCH
When equipped with a tilt and power or manual recline
combination, your wheelchair will include a mercury
switch located inside the shroud, on the right side of the
chair. The purpose of the mercury switch is to control the
combination of the total tilt / recline angle.
This mercury switch can be manually turned to change the
total tilt / recline angle to a desired or comfortable level
for the end user. The total tilt and recline angle should
never exceed the horizontal plain (180°). Technicians must
watch for a possible tilt actuator behind the seat that would
reduce the total tilt / recline limit. The total tilt and recline
angle should be limited prior to contact between the shroud
and the tilt actuator.
IX. OPERATING GUIDE
u
!
WARNING
Make sure the wheelchair is on a
level surface
before
proceeding with recline mode.
4-WAY TOGGLE
Increasing Recline Angle
Pull the four-way toggle switch
back until the desired recline
angle is achieved and release.
Decreasing Recline Angle
To reverse the recline angle
direction: Release the four-way
toggle switch to the neutral
position for a minimum of 1
second and pull the four-way
toggle switch back until the
desired recline angle is achieved
and release.
PUSH BUTTON SWITCHES
Increasing Recline Angle
Push the 2nd button until the desired
recline angle is achieved and release.
Decreasing Recline Angle
To reverse the recline angle direction:
Release the 2nd button to the neutral
position for a minimum of 1 second
and push the same button until the
desired recline angle is achieved and
release.
N. POWER RECLINE
(Standard Operating Instructions)
LEVEL SURFACE
2nd push button
Tip-over Limit Switch
A
B
A
B
A
B
Summary of Contents for R HybridHybrid
Page 1: ...Rev 01 February 2017...
