AMX Novara SP-08-E-US, Instruction Manual

Page: 32 / 37

Programming Ethernet Keypads
25 Instruction Manual - Novara Ethernet Keypads
Terminal Commands (Cont.)
Command Description
PING [ADDRESS] Pings an address (IP or URL), to test network connectivity to and confirms the
presence of another networked device.
The syntax matches the PING application in Windows or Linux.
Example:
>ping 192.168.29.209
192.168.29.209 is alive.
REBOOT Reboots the keypad.
Example:
>REBOOT
Rebooting...
RENEW DHCP Renews/Releases the current DHCP lease for the keypad.
Example:
>RENEW DHCP
RESET FACTORY Resets the device’s stored parameters to factory default state including removal of
all security settings, resetting to DHCP.
This command will cause an automatic reboot.
Note : This command does not reset the device to the factory software image.
SET CONNECTION Set the master connection settings interactively, allowing the user to specify the
mode.
• If mode is TCP or UDP, the master URL and port number can be specified as well.
• If AUTO is selected, the System number can be specified.
• After all data is entered, if the parameters have changed, the Module will
disconnect from the Master, and begin trying to connect with the new settings.
Note : These changes do not require a reboot to take effect.
SET DEVICE Set the device number, and store in non-volatile memory.
Syntax:
SET DEVICE <num>
The valid range of device numbers is 0-31999.
• If the user enters a number outside that range, then no change will be made and
the Module will issue an error message.
• A Device Number of ‘0’ means that the Module will accept the auto-assigned
device number from the Master.
• If the new device number is different from the old device number, the Module will
disconnect from the Master, and begin trying to connect with the new settings.
Note : These changes do not require a reboot to take effect.