AMX Novara SP-08-E-US, Instruction Manual

Page: 30 / 37

Programming Ethernet Keypads
23 Instruction Manual - Novara Ethernet Keypads
Telnet Commands
The commands listed in the following table can be sent directly to the Keypad via a Telnet terminal session.
In your terminal program, type “ Help ” or a question mark (“?”) and < Enter > to access the Help Menu, and display the
Program port commands described below:
Terminal Commands
Command Description
? or Help Display this list of commands.
DEVICE STATUS Display device status of a specified device, port, system (<D:P:S>).
Example:
>device status 14021:1:1
Device Status
-------------
Device 14021 AMX LLC,SP-08-E-US,v1.0.25 contains 1 Ports.
Port 1 - Channels:8 Levels:1
MaxStringLen=64 Types=8 bit MaxCommandLen=64 Types=8 bit
The following input channels are on:1,2,3,4
The following output channels are on:None
Level 1=0 Supported data types=UByte,UInt
>
EXIT Exit the telnet session
FACTORYFWIMAGE Reset unit to factory firmware image and reboots the Module.
GET CONFIG Display the current connection settings.
Example:
>get config
Device number: 10001
Connection Settings
--------------------------------
ICSNet/Ethernet: Ethernet
Mode: URL
System Number: 1
Master IP/URL: 192.168.1.211
Master Port: 1319
Username:
Password:
IP Settings
--------------------------------
HostName: localhost
Type: DHCP
IP Address: 192.168.1.53
Subnet Mask: 255.255.255.0
Gateway IP: 192.168.1.1
MAC Address: 00:60:9f:94:2d:4f
DNS Servers
--------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.20.7
Entry 2: 192.168.20.9
Note : The system number and IP addressing information displayed is reflective of
actual operating values, not stored parameters.
GET CONNECTION Show the Module connection information.
Example:
>get connection
Connection Settings
------------------------------
ICSNet/Ethernet: Ethernet
Mode: URL/TCP
System Number: 1
Master IP/URL: 192.168.1.211
Master Port: 1319
Username:
Password:
GET DEVICE Display the device number.