![background image](http://html.mh-extra.com/html/amx/netlinx-nxb-knx/netlinx-nxb-knx_operation-reference-manual_2938117060.webp)
Appendix A: Telnet Commands
54
NXB-KNX Operation/Reference Guide
Terminal Commands (Cont.)
Command
Description
SET DNS
Sets up the DNS configuration.
This command prompts you to enter a Domain Name, DNS IP #1,
DNS IP #2, and DNS IP #3.
Then, enter Y (yes) to approve/store the information in the NXB-KNX.
Entering N (no) cancels the operation.
Note
:
The device must be rebooted to enable new settings.
Example:
>SET DNS
-- Enter New Values or just hit Enter to keep current
settings --
Enter Domain Suffix: amx.com
Enter DNS Entry 1 : 192.168.20.5
Enter DNS Entry 2 : 12.18.110.8
Enter DNS Entry 3 : 12.18.110.7
You have entered: Domain Name: amx.com
DNS Entry 1: 192.168.20.5
DNS Entry 2: 12.18.110.8
DNS Entry 3: 12.18.110.7
Is this correct? Type Y or N and Enter -> Y
Settings written. Device must be rebooted to enable
new settings
SET JAVA HEAP
Set the amount of memory allocated for the Java pool. This is the
current Java memory heap size as measured in Megabytes.
• Valid values = 5M - 35M
• Recommended default = 32M
Note
: This setting does not take effect until the next reboot.
SET ETHERNET MODE <CMD>
This command sets the current ethernet configuration settings -
auto OR speed = 10 | 100, duplex = full | half.
Example:
set ethernet mode auto
set ethernet mode speed=100 duplex=full
Note
: See GET ETHERNET MODE.
SET FTP PORT
Enables/Disables the NXB-KNX’s IP port listened to for FTP
connections.
Note
:
The NXB-KNX must be rebooted to enable new settings.
Example:
>SET FTP PORT
FTP is enabled
Do you want to enable (e) or disable (d) FTP (enter e or d):
FTP enabled, reboot the NXB-KNX for the change to take affect.
SET HTTP PORT
Sets the NXB-KNX’s IP port listened to for HTTP connections.
Note
:
The NXB-KNX must be rebooted to enable new settings.
Example:
>SET HTTP PORT
Current HTTP port number = 80
Enter new HTTP port number (Usually 80) (0=disable HTTP):
Setting HTTP port number to
New HTTP port number set, reboot the NXB-KNX for the change
to take affect.