![background image](http://html1.mh-extra.com/html/amx/fg2105-08/fg2105-08_operation-reference-manual_2937837154.webp)
Programming
148
NI-3101-SIG Signature Series NetLinx Integrated Controller
Configuration Port Commands (Cont.)
Command
Description
SET THRESHOLD
Sets the Master's internal message thresholds.
Example:
>SET THRESHOLD
-- This will set the thresholds of when particular tasks are
pended. The threshold is the number of messages queued before a
task is pended.--
--Use extreme caution when adjusting these values.--
Current Interpreter Threshold = 2000
Enter new Interpreter Threshold (Between 1 and 2000)
(Default=10):
Once you enter a value and press the ENTER key, you get the following
message:
Current Lontalk Threshold = 50
Enter new Lontalk Threshold (Between 1 and 2000) (Default=50):50
Current IP Threshold = 600
Enter new IP Threshold (Between 1 and 2000) (Default=200): 600
Setting Thresholds to: Interpreter 2000
Lontalk 50
IP 600
New thresholds set, reboot the Master for the changes to
take affect.
SET TIME
Prompts you to enter the new time for the Master.
When the time is set on the Master, the new time will be reflected on all
devices in the system that have clocks (i.e. touch panels). By the same
token, if you set the time on any system device, the new time will be
reflected on the system’s Master, and on all connected devices.
This will not update clocks on devices connected to another Master (in
Master-to-Master systems).
Example:
>SET TIME
Enter Date: (hh:mm:ss) ->
SET TIMELINE LOOPCNT
Sets the Master's timeline/event max loopcount.
SET UPD BC RATE
Set UDP broadcast rate. A broadcast message is sent by the Master to
allow devices to discover the Master. This command allows the broadcast
frequency to be changed or eliminate the broadcast message.
Example:
>SET UPD BC RATE
Current broadcast message rate is 5 seconds between messages.
Enter broadcast message rate in seconds between messages
(off=0 ; default=5) (valid values 0-300):
Once you enter a value and press the ENTER key, you get the following
message:
Setting broadcast message rate to 300 seconds between messages
New broadcast message rate set.
SET URL <D:P:S>
Prompts you to enter the URL address and port number of another Master
or device (that will be added to the URL list). Then, enter Y (yes) to
approve/store the new addresses in the Master.
Entering N (no) cancels the operation.
Example:
>SET URL [0:1:0]
No URLs in the URL connection list
Type A and Enter to Add a URL or Enter to exit. -> a
Enter URL -> 192.168.21.200
Enter Port or hit Enter to accept default (1319) ->
Enter Type (Enter for permanent or T for temporary) ->
URL Added successfully.