Decoder Configuration Options
53
N3000 Series User Manual
Gratuitous ARP
Enable the Decoder to send a periodic Address
Resolution Protocol (ARP) packet to the network.
ARP Interval (secs)
Determine how often (in seconds) the unit transmits
gratuitous ARP packets.
Unsolicited Status
Enable the Decoder to send a periodic status packet to
the
Send Status Address
described below.
Send Status Address
When
Unsolicited Status
is enabled, the Decoder sends
a periodic status packet to the IP address specified
here.
Status Interval (secs)
Determine how often (in seconds) the unit transmits
status packets.
Discovery Packet
Transmit
Enable the SVSI multicast discovery service (which is
used to identify units).
This is useful for larger network integrations when
broadcast packets will not cover the entire network.
Enabled by default.
Discovery Interval
(secs)
Determine how often (in seconds) the unit transmits
discovery packets.
IR Command Holdoff
Set the delay between IR command portions. The
default setting is 25 ms.
IR commands are sent in two parts. This setting is the
time (in milliseconds) between transmission of part
one and part two. The second part of the command is
inverted for confirmation purposes.
IR Repeat Holdoff
Set the repeat delay between IR commands. The default
setting is 90 ms.
This is the amount of time before a new command is
sent. For example, when pressing and holding the
volume button on a remote control, this is how long
until the command is repeated.
IGMP Joins on Stream
Loss
Enable to send Internet Group Management Protocol
(IGMP) join messages when no incoming stream is
detected.
IGMP Join Interval
Delay in seconds between sending IGMP join messages
(if
IGMP Joins on Stream Loss
is enabled).
Enable SNMP
Enable to allow the device to send Simple Network
Management Protocol (SNMP) packets.
TABLE 18
Settings Page: Advanced Settings (Cont.)
Option
Description
Notes