![background image](http://html1.mh-extra.com/html/amx/and-nmx-dec-n3232/and-nmx-dec-n3232_instruction-manual_2938519015.webp)
Installing and Configuring Your AV Equipment
15
N3000 Series User Manual
NOTE:
If the computer does not need Internet access, you can simply enter a unique 169.254.xxx.xxx IP address with a 255.255.0.0
subnet mask. Contact your network administrator if you are unsure of how to configure the existing network. SVSI units in Auto IP
mode will not self-assign in the 169.254.0.xxx range.
NOTE:
If the computer has a statically-assigned IP address, click the Advanced button. Then click Add to enter a unique
169.254.xxx.xxx address with a Subnet Mask of 255.255.0.0 and a Default Gateway of 169.254.1.1.
Step 2: Connecting Decoders to the Network
The digital connection from a Decoder’s video out port (
HDMI OUT
or
DVI-D OUTPUT
, depending on model) to a display is
accomplished using the appropriate cable/adapter. N3000 units support embedded audio input and output on the HDMI ports;
however, some display devices (e.g., many monitors)
do not
support embedded audio. When using such a display, use the
AUDIO
port for separate transmission of sound and turn
HDMI Audio
off (on the
Settings
page) to avoid video display issues.
Power is supplied via a PoE-enabled switch or an external power supply. Refer to the following steps and
Figure 11
for guidance.
1.
Using a Cat-5 cable, connect your SVSI Decoder’s
P0
port to a PoE-enabled switch. This provides both network and power
connection. In non-PoE applications connect a 12V regulated power supply (N9312) to the two-pin terminal block plug
connector (labeled
+12V 2A
).
2.
Connect the display you would like to use for that Decoder (monitor, projector, etc.) to the Decoder’s video out port (
HDMI
OUT
or
DVI-D OUTPUT
) using the appropriate cable/adapter. For
HDMI OUT
, this must be a digital video connection.
FIG. 11
Decoder Connections
3.
Repeat Steps 1 and 2 until all Decoders are installed on the network.
4.
Once the Decoders and displays are connected and powered up, the LocalPlay screen appears on the displays.
5.
Enable the
Use the following IP
address
option, and enter the
static IP address provided to you
by your network administrator.
N3000 Decoder
PoE-Enabled Switch
Network
HDMI/DVI-D Cable/Adapter (model-dependent)
Cat-5 Cable