Encoder Configuration Options
34
N3000 Series User Manual
Network Setup Section
The
Network Setup
section of the
Settings
page is shown in
Figure 27
. Options are described in
Table 6
.
FIG. 27
Network Setup Section
TABLE 6
Settings Page: Network Setup Settings
Option
Description
Notes
IP Mode
Configure the IP address mode. When set to
AUTO IP
,
an IP Address in the range of 169.254.xxx.xxx with
Netmask
of 255.255.0.0 and
Gateway
address
of
169.254.1.1 will be automatically assigned to the
N3000 Encoder by the control software. When set to
DHCP
,
an IP Address in the range of the DHCP server on
the network will be automatically assigned to the
N3000 Encoder. When set to
STATIC
, an
IP address
,
Netmask
, and
Gateway
address
must be manually
entered.
Using
DHCP
is generally not recommended. If the
device is set to
DHCP
and fails to receive an address
from the DHCP server in time, it will revert back to the
AUTO
IP
Address (169.254.xxx.xxx) until the unit is
rebooted.
IP address
View the current IP address of the N3000 Encoder.
When in
STATIC
mode, you may enter a new IP address
into this field.
Netmask
View the current
Netmask
of the N3000 Encoder. When
in
STATIC
mode, you may enter a new
Netmask
into
this field.
Gateway address
View the current
Gateway address
of the N3000
Encoder. When in
STATIC
mode, you may enter a new
Gateway address
into this field.
Manual DNS
Enable to override the DNS selection.
This is used for RTMP.
DNS #1 and #2
Specifies the main servers for use for DNS.
Ping Test
Test connection by specifying an IP address or URL to
ping. Click the
Ping
link to initiate the test.
This is useful when in RTMP mode for verifying that
the unit can access the RTMP server.
Trial Save
Click to initially save IP address changes. Once you log
in to the unit using the new address, you will be able to
confirm and accept the changes permanently.